LPC2478 with 7 inch TFT Touchscreen

Product Information

Development Solution
- C language , ARM7 base on LPC from NXP
- Embedded uCLinux

Clip Demo
- Booting uClinux from SD Card , Bootloader copy kernel image from SD Card to SDRAM and Boot
- Checkout first demo of BlueScreen SUN, a PoS demo!!!

Software Complier
- Keil RealView Complier V3.2 (IDE , C Complier for Program and Debug)
Note: Please fill inform to register before download Evaluate Version . This Evaluate version is only limit code size. (32 Kbytes) . After register you can see this link 
- YAGARTO - Yet another GNU ARM toolchain
- OpenOCD 
- GNU Toolchain For ARM 
- WinARM 
- IAR Embedded Workbench for ARM 
- Rowley Crossworks ARM compiler 

Software Tool
- Flash Magic ( Program by send hex code load into Target board If you don't need for Debug)
- IMG to HEX Thank you Mr. Krisda Yingkayun
- Program Bitmap to Hex converter - bmp2h_conv (RAR , ThaiEasyElec's Program Bitmap Picture file convert to Hex code for use in your C program)
- Program Bitmap to Hex converter (EXE File , ThaiEasyElec's Program Bitmap Picture file convert to Hex code for use in your C program)
- RGB Mixer Software Thank you Mr. Krisda Yingkayun 



Example Source Code for Keil
- POS Demo !!

App Note:
- ANBSS1_00_01_LCD_Installation_Guide.pdf
- How to Boot uCLinux? / Compile Kernel?
- Bluescreen SUN and USB Wifi
- More.. to be continued

Feature Summary
- NXP’s ARM7 LPC2478
- 2 of 16-bit Micron’s MT48LC16M16A2P-75 SDRAM providing 32-bit, 64MB memory
- Connector for 480x272 pixels TFT LCD with touch screen
- Connectors for 800x480 pixels TFT LCD and 4-wire resistive touch screen panel
- SD card socket (connected via SPI interface) support up to 2GB capacity (High capacity: ‘HC’ type not supported)
- On board 8kB EEPROM (the last 128 bytes are reserved for screen calibrated parameters)
- Serial Port 0 with selectable UART connector (TTL 3.3v with 5v tolerant) or female DB9 connector (RS232) for command line interface and in-system programming (select by a jumper)
- Serial Port 1 with full modem signals on male DB9 connector
- 7 GPIO ports
- 1 port ThaiEasyElec’s module connector consisting of SPI and UART signals from MCU (can be used as 10 GPIO ports)
- One USB host interface with USB type A connector and power switch IC LM3526M-L
- One USB device interface with mini-B USB connector (the board cannot be powered from USB connector)
- Connector for ThaiEasyElec’s DP83848 Ethernet module
- JTAG connector for programming and debugging
- Connectors for 9-16VDC power supply (DC jack and screw-type)
- Buzzer

Point Of Sale DEMO !!

Bình luận của khách: